[3DMakerWorld] Adafruit MCP4725 Breakout Board

Description: Key Features: Great for audio / analog projects Convert Digital to Analog Control it via I2C Connect two of these DACs on one I2C bus Your microcontroller probably has an ADC (analog -> digital converter) but does it have a DAC (digital -> analog converter)??? Now it can! This breakout board features the easy-to-use MCP4725 12-bit DAC. Control it via I2C and send it the value you want it to output, and the VOUT pin will have it. Great for audio / analog projects, such as when you cant use PWM but need a sine wave or adjustable bias point. The ADDR/A0 pin is broken out so you can connect two of these DACs on one I2C bus, just tie that pin of one high to keep it from conflicting. Some nice extras with this chip: for chips that have 3.4Mbps Fast Mode I2C (Arduinos dont) you can update the Vout at ~200 KHz. Theres an EEPROM so if you write the output voltage, you can store it so if the device is power cycled it will restore that voltage. The output voltage is rail-to-rail and proportional to the power pin so if you run it from 3.3V, the output range is 0-3.3V. If you run it from 5V the output range is 0-5V. Wiring it up is easy - connect VDD to your microcontroller power pin (3-5V), GND to ground, SDA to I2C Data (on the Arduino Uno, this is A4 on the Mega it is 20 and on the Leonardo digital 2), SCL to I2C Clock(on the Arduino Uno, this is A5 on the Mega it is 21 and on the Leonardo digital 3) and listen on VOUT. Item Specifics 1 - 6-pin header Works with both 3.3V or 5V logic. This board/chip uses I2C 7-bit address, you can use 0x62 or 0x63

Price: 12.64 USD

Location: Lenexa, Kansas

End Time: 2025-01-14T17:01:46.000Z

Shipping Cost: N/A USD