Behringer

[ Adafruit ADA-2130 ] Mono 2.5W Class D Audio Amplifier - PAM8302

Description: This super small mono amplifier is surprisingly powerful - able to deliver up to 2.5 Watts into 4-8 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2.0V-5.5VDC. Since the amp is a class D, its very efficient (over 90% efficient when driving an 8Ω speaker at over half a Watt) - making it perfect for portable and battery-powered projects. It has built in thermal and over-current protection but we could barely tell it got hot. There's even a volume trim pot so you can adjust the volume on the board down from the default 24dB gain. This board is a welcome upgrade to basic "LM386" amps! The A+ and A- inputs of the amplifier go through 1.0uF capacitors, so they are fully 'differential' - if you don't have differential outputs, simply tie the Audio- pin  to ground. The output is "Bridge Tied" - that means the output pins connect directly to the speaker pins, no connection to ground. The output is a high frequency 250KHz square wave PWM that is then 'averaged out' by the speaker coil - the high frequencies are not heard. All the above means that you can't connect the output into another amplifier, it should drive the speakers directly. Comes with a fully assembled and tested breakout board. We also include header to plug it into a breadboard and a 3.5mm screw-terminal blocks so you can easily attach/detach your speaker. You will be ready to rock in 15 minutes! Speaker is not included, use any 4 ohm or greater impedance speaker. Output Power: 2.5W at 4Ω, 10% THD, 1.5W at 8Ω, 10% THD, with 5.5V Supply 50dB PSRR at 1KHz Filterless design, with ferrite bead + capacitors on output. Fixed 24dB gain, onboard trim potentiometer for adjusting input volume. Thermal and short-circuit/over-current protection Low current draw: 4mA quiescent and 0.5mA in shutdown (due to pullup resistor on SD pin) Note: The terminal block included with your product may be blue or black.

Price: 9.95 USD

Location: Columbiana, Ohio

End Time: 2024-09-17T18:13:38.000Z

Shipping Cost: N/A USD

Product Images

[ Adafruit ADA-2130 ] Mono 2.5W Class D Audio Amplifier - PAM8302

Item Specifics

Return shipping will be paid by: Seller

All returns accepted: Returns Accepted

Item must be returned within: 30 Days

Refund will be given as: Money back or replacement (buyer's choice)

Return policy details:

Brand: Unbranded

MPN: Does not Apply

Recommended

20pcs Squid Jig Wood Shrimp Luminous Lure for Cuttlefish Octopus 11cm 10g
20pcs Squid Jig Wood Shrimp Luminous Lure for Cuttlefish Octopus 11cm 10g

$19.99

View Details
Los Angeles Chargers NFL Football Sticker Decal S570
Los Angeles Chargers NFL Football Sticker Decal S570

$2.70

View Details
18 in 1 Portable Snowflake Multi Tool Stainless Tool Screwdriver Key Chain Camp
18 in 1 Portable Snowflake Multi Tool Stainless Tool Screwdriver Key Chain Camp

$2.99

View Details
DETROIT LIONS EMBROIDERED IRON ON PATCH 2.5” X 2.5” FREE SHIPPING
DETROIT LIONS EMBROIDERED IRON ON PATCH 2.5” X 2.5” FREE SHIPPING

$4.79

View Details
🔥SUPER FAST⚡-4/5⭐️star Sticker-❄️Read DESCRIPTION
🔥SUPER FAST⚡-4/5⭐️star Sticker-❄️Read DESCRIPTION

$3.25

View Details
MonopolyGo 5⭐Sticker with the name of MR CEREBRO WITH🥇SUPERFAST SENDING🥇
MonopolyGo 5⭐Sticker with the name of MR CEREBRO WITH🥇SUPERFAST SENDING🥇

$2.99

View Details
BALTIMORE RAVENS IRON ON PATCH
BALTIMORE RAVENS IRON ON PATCH

$3.99

View Details
Bills Patch Iron on or sew on  embroidery 2"
Bills Patch Iron on or sew on embroidery 2"

$5.00

View Details
Anime Space Fighters Type-C RESCULPT! (Set of 6) Wargame Miniatures
Anime Space Fighters Type-C RESCULPT! (Set of 6) Wargame Miniatures

$10.00

View Details
Thermal Shipping Label Holder for 4x6 Rolls and Fan-Fold Label Printer Accessory
Thermal Shipping Label Holder for 4x6 Rolls and Fan-Fold Label Printer Accessory

$7.99

View Details