Adafruit NeoPixel Digital RGB LED Strip - White 60 LED - WHITE

Description: You thought it couldn't get better than our world-famous 32-LED-per-meter Digital LED strip (http://adafruit.com/products/306) but we will prove you wrong! You wanted twice the LEDs? We got it (well, its 1.875 times as many but that's within a margin of error). You wanted thinner strips? Now only 12.5 mm wide, 10 mm if you remove the strip from the casing. You wanted less noticeable strip color - this strip has white-colored flex PCB, which will be less visible against white-painted walls. This is the strip with white flex PCB, its identical to the black 60 LED/meter except it has a different color mask on the flex strip These LED strips are even more fun and glowy. There are 60 RGB LEDs per meter, and you can control each LED individually! Yes, that's right, this is the digitally-addressable type of LED strip. You can set the color of each LED's red, green and blue component with 8-bit PWM precision (so 24-bit color per pixel). The LEDs are controlled by shift-registers that are chained up down the strip so you can shorten or lengthen the strip. Only 1 digital output pin are required to send data down. The PWM is built into each LED-chip so once you set the color you can stop talking to the strip and it will continue to PWM all the LEDs for you. The strip is made of flexible PCB material, and comes with a weatherproof sheathing. You can cut this stuff pretty easily with wire cutters, there are cut-lines every 0.65"/1.7cm (1 LED each). Solder to the 0.1" copper pads and you're good to go. Of course, you can also connect strips together to make them longer, just watch how much current you need! We have a 5V/2A supply that should be able to drive 1 meter (http://www.adafruit.com/products/276) (depending on use) and a 5V/10A supply that can drive up to 4 meters (http://www.adafruit.com/products/658) (depending on use) You must use a 5V DC power supply to power these strips, do not use higher than 6V or you can destroy the entire strip They come in 4 meter reels with a 2 or 3-pin JST SM connector (http://www.adafruit.com/datasheets/JSTSM.pdf) on each end and separated power/ground wires. These strips are sold by the meter! If you buy 4 meters at a time, you'll get full reels with two connectors. If you buy less than 4m, you'll get a single strip, but it will be a cut piece from a reel which may or may not have a connector on it. If the piece comes from the end of the reel, the connector may be on the output end of the strip!

Price: 24.9 USD

Location: New Castle, Delaware

End Time: 2025-01-14T16:58:34.000Z

Shipping Cost: 4.49 USD