Black Holder For HTRC P3648 Charger For Wall Mount, Pegboard, Or Ryobi Link

Description: Color = black. See other listing for green This custom designed holder is specifically designed to hold 1 HTRC P3648 Smart Charger. The ends are left open so the cables can be inserted without obstruction and access to the power switch is easy to reach. There are small notches in the base to position the charger and keep it from sliding. The arms on the front are just outside the display panel and gently pinch the charger. The Charger is held by sitting on the holder in the notches and held in place by the U-shaped brackets. The 4 trapezoidal bumps on the back are not affected and the holder keeps the charger sufficiently away from the wall/surface. It can be mounted in a variety of ways including screws to the wall, pegboard*, and Ryobi Link Wall Rails. The overall height does not exceed the height of 1 Ryobi Link Wall Rail and thus does not block tools above or below the rail. It includes 6 pegs: 3 curved and 3 straight if you choose to mount it to pegboard. If mounting to the wall with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw (not included) to hold it into place. The Charger is NOT included and shown in photos for reference only. It was designed specifically for the HTRC Smart Charger Model #P3648. * Note that there are many different types of pegboard and some may not work. This is designed to work on 1/8" thick masonite pegboard with holes at 1" (25.4mm) on center only. Dimensions: It is 6.5" x 3.6" x 4.5" (164mm x 91mm x 115mm). This is uniquely designed and 3D-printed by the Seller in the USA. Items are lightweight and 3D-printed in PLA plastic. Due to the printing process, there may be some minor imperfections which are mostly likely to be on the bottom/back side, not exposed to view. PLA plastic is made from a renewable resource and is biodegradable and eco-friendly. 3D Printing involves the heating and depositing of material on a flat board one layer at a time, thus most exposed sides have small, fine lines. Infill (non-exposed) areas are not solid plastic.

Price: 16.95 USD

Location: Lexington, Kentucky

End Time: 2024-07-28T07:38:23.000Z

Shipping Cost: 0 USD