Control4 C4-16ZAMSV3 Power Supply after market kit FREE SHIPPING normal duty

Description: This is PSB for control4 16 matrix this is a replacement and not the original made by control4 - For repairs of dead PSB in matrix switches This one can provide up to OEM energy for stable long term. For most users the normal is all you needs. If your unit is dead or if you know that your power board is defective you will need to upgrade to the new expensive matrix switches but if you are short you can replace the power supply at your matrix and most probably get few more years of service be advice that this PS will provide power as needed but it is not identical to the one that fail on you . installation will take 30-45 min and include disconnect the defectives PS and install the replacement include connected the power wire in and out if you are little handy this is for you why upgrade for 1000 or 2000 when you can get the same old good service for few more years this one is not direct fit -you will use only 1 or 2 out of the 4 screws that hold the old PSB INPOT VOLTAG 90-230v (USA OR ERUP) Look at the pictures it show how to replace it. Also recommend to replace the memory battery, before.. make sure to maintain the wire color in order for the psb to work. This is not direct replacement as you will need to add ground wire and connect wires to the PSB .but it is relatively simple. 1.Input features Ac Input-AC 85-264VDC Input-DC 110-370VFrequency range (Hz)47-63 Input current (mA)1.0/115VAC 0.5/230VACInrush Current(A)Cold start: 10A/230VACOutput efficiency(TYP80%No-load standby (mW)150mW/230VAC2.OutPut features Output Voltage (VDC)5.0V Output Voltage Accuracy 1% Rated current (ADC) 3.0A Rated power (W) 15W Ripple and noise (MVP - p) Rated input Voltage, 20 MHZ band 100mV Linear adjustment rate (Full load) 1% Load regulation (10-100% load) 3% Start/ up time 2000ms, 30ms/115VAC 1000ms, 30ms/230VAC Keep time (ms) 16ms/115VAC 50ms/230VAC Overload protection (Rated input voltage) Rated output power of 115%-150% Protection mode: hiccup mode, the abnormal condition of abnormal load can be automatically returned Short Circuit Protection (Rated input voltage) Long short circuit, automatic recovery Over current protection (Rated input voltage) 1.1 times Io Start delay holding time (ms) (Vin:230V AC) 500ms Loss Electrical ,retention time (ms) (Vin:230V AC) 20ms3.General Features Operating Temperature()-30-70Operating humidity (RH) 20-90%,No condensation Temperature Drift Coefficient 0.02%/ Storage Temperature and Humidity -40+85 10-95%RHSwitching frequency (KHz) 5-65 (Frequency Conversion Control Chip) Security Level CLASS BEl ectromagnetic CompatibilityAdaptation: EN55022 (CISPR22) Class B en61000-3-2, -3 Not Rated for wet conditions

Price: 111 USD

Location: Port Jefferson, New York

End Time: 2023-11-20T14:41:29.000Z

Shipping Cost: 0.01 USD