EGW HK VP9, VP40, P30 Red Dot Mounting Plate for Trijicon RMR, SRO/Holosun 407C

Description: THIS DOES NOT FIT MODELS THAT HAVE AN OPTICS CUT SLIDE FROM THE FACTORY. THIS IS ONLY FOR USE IN THE MODELS WITH JUST A DOVETAIL CUT FROM THE FACTORY. IF YOU ARE NOT FAMILIAR WITH WHICH ONE YOU HAVE, PLEASE CALL THE MANUFACTURER AND CONFIRM BEFORE PURCHASING! Mounting Hardware is IncludedThis mount fits:H&K VP9H&K VP9SKH&K VP40H&K P30H&K P30LH&K P30SKH&K 45H&K 45CThis mount is NOT intended for use with the optics ready version of these pistols.This mount does not fit:HK USP Any Optics Ready ModelsMaterial: 7075 AluminumCoating: Matte Black HardcoatOverall Length: 1.780"Overall Width: 1.1"Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set ScrewRed Dot Fitment: Trijicon RMR / SRO, Holosun HS507COur red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.Installation Instructions- Remove the rear sight*- Install the EGW Sight Mount in the dovetail- Tighten set screw (if applicable)- Place the red dot sight on the EGW Sight Mount(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)- Apply blue Loctite to the provided mounting screws- Torque mounting screws to 15in/lbs2 Flat Head Cap Screws - Provided for Trijicon RMRThe screws that are included with this mount require a 5/64'' allen wrench for installation.

Price: 49.99 USD

Location: Quakertown, Pennsylvania

End Time: 2024-11-03T18:30:33.000Z

Shipping Cost: 0 USD