ESP32 With 7V to 40 Operating input Voltage. Made in USA Arduino Programmable

Description: This ESP32 development board has an integrated switch mode regulator with 5V at 200mA output. Low Deep Sleep current and pin numbers on the top of the PCB. All boards ship with Wroom-32E modules installed. Made in and ships from the USA. Other than the Wroom-32E module it has an Si Labs CP2104 USB to Serial converter, A 40V switching regulator to power the ESP32 and provide 200mA output on the 5V output or 3.3V output to power external peripherals such as NeoPixels. There is a Reset switch an RGB LED. There are two RGB LEDs on the board. One has the red and green LEDs hooked up to the CP214 to signal transmit and receive activity and the other is connected to three IO pins on the ESP32S module. The board supports auto-download from the Arduino environment and will automatically be set in download mode by the downloader. Once the download is complete the board will be reset, just like a normal Arduino board. All the required capacitors and pull-up resistors are fitted on the board. The board can be powered from an external power supply of up to 40V or the USB connector or both. The module can be used in cars or trucks with 12V or 24V electrical systems without additional protection circuitry. The module can also be powered from solar panels without additional circuitry. Unlike most other boards this one fits on a breadboard and has one row of pins accessible on each side of the board. Most of the pins of the ESP32 module are available on the external pins. The board ships with header pins but they are not soldered to the board. The module can be programmed directly from the Arduino environment without pushing any buttons. The upload speed is 921600 bps. 240 MHz dual core Tensilica LX6 microcontroller with 600 DMIPS Integrated 802.11BGN HT40 Wi-Fi transceiver, baseband, stack and LWIP Integrated dual mode Bluetooth (classic and BLE) 4 MByte flash 3 x UARTs, including hardware flow control 3 x SPI2 x I2S12 x ADC input channels2 x DAC2 x I2CPWM/timer input/output available on every GPIO pinSDIO master/slave 50 MHzSD-card interface supportLow Sleep current Schematic and example code can be found on forum dot ezsbc dot com

Price: 12.95 USD

Location: Prescott Valley, Arizona

End Time: 2024-08-26T22:55:03.000Z

Shipping Cost: N/A USD